Lexia-3 Citroen/ Peugeot Diagnostic > >
Product Name: Lexia-3 Citroen/ Peugeot Diagnostic
Part No.: A104
Net Weight: 3KG
LEXIA-3 Interface latest version, works for both Citreon and
Dealer diagnostic scanner for comprehensive Citroen and Peugeot
cars diagnostic. You can do all as a authorized dealer does.This
diagnostics software allows you to perform complete diagnostics of
all from 1995 untill present models. Diagnostics is performed via
OBD-II connector ( which is located near steering wheel) or via
manufacturer-specific connector ( only older cars, pre-2001) .
Unlike other universal car scanner tools which only read fault
codes, this software performs nearly ALL the functions like the
original dealer diagnostic tool. Our diagnostic interface contains
K-Line multiplexor, CAN-BUS interfaces and SAE J1850 bus ( both PWM
and VPW) .
The following diagnostic functions are supported:
Displays complete identification of control unit, e.g. part number,
software/ hardware version, manufacturer, etc...
Read fault codes
Displays all stored and pending fault codes with complete
description ( e.g. " Rail pressure - too low pressure " ) .
Program supports report printing or copy to clipboard.
Clear fault codes
This function clears all stored fault codes and other diagnostic
Auto-scan ( complete car scan/ test)
Detects all ECUs ( electronic control units) installed in car and
reads all diagnostic fault codes.
Program displays live Data like Engine Speed, Battery voltage,
Oxygen Sensor, Coolant Temperature, etc. Values can be displayed in
graph, 9 values at once, or full listing ( all measured values) .
Logging to file is also supported, which allows offline analysis.
Actuator test activates particular actuator ( e.g. turn on fuel
pump, lock/ unlock wheel, lock/ unlock doors, cut off fuel, etc..)
Programming functions/ Adaptation
This feature is of great importance in all vehicles because systems
like Engine control units, Immobilizers, Airbags, Alarms, Body
Control Units, and some others, require you to perform reset or
programming procedures after car repair is done, or even
configuration after replacing broken Control Unit.
Hardware and software requirements
Software requires at least Intel Celeron/ Pentium III 400 MHz, 128
MB RAM, 50MB free HDD space and USB 1.1 port ( USB 2.0 recommended)
and Microsoft Windows 98 SR2/ 2000/ XP with the latest service pack
If customer requires, we can prepare ready to work PC.
Main unit with OBD-2 cable
16pin F to 2pin cable
TWINB GT1+ STAR Images